Drilling & boring
Directional drilling in Atlanta and Fulton County
One rig, two pits, and the line goes under Peachtree without anyone cutting Peachtree. This is the method the rest of this site is built on, done by a crew based twenty minutes from the Perimeter.
Serving Atlanta · Fulton County
Davis Underground Solutions, Inc.
Directional drilling and boring across Georgia; locates, bore plan and utility coordination handled. More about Davis Underground Solutions →
The method, in Atlanta terms
A directional drill is parked at one end of the run, in a lane closure, a driveway or a planting strip. It drills a pilot hole with a steerable head that a crew member tracks from the surface every ten feet, so the bore stays at the planned depth under the street, the sidewalk, the creek or the parking deck ramp. The hole is reamed to size and the pipe or conduit is pulled back through it in one piece. Nothing between the entry pit and the exit pit is opened. In a city that resurfaces a street and then forbids cutting it for years, that is the only practical way to add a line.
What is under the street
The ground under an Atlanta street is as crowded as the street itself: water and sewer from the City of Atlanta Department of Watershed Management, Georgia Power duct banks, Atlanta Gas Light mains, MARTA conduit, traffic signal interconnect, and generations of telecom. A bore here is planned around the Georgia 811 marks and potholed where the locate is not enough.
Rock
Fulton County is Piedmont: a few feet of red clay over saprolite, and under that the granite and gneiss that show at the surface as outcrops in the parks and the road cuts. North of the city the rock can be within reach of a shallow bore; along the Chattahoochee and the creeks it is deeper under alluvium. A crew that drills Atlanta every week carries the bit, the mud motor and the patience for it.
Permits and crossings
Rights-of-way are permitted by the City of Atlanta Department of Transportation inside the city, Fulton County Public Works in the unincorporated county, each of the North and South Fulton cities on their own streets, GDOT District 7 on state routes and the interstates, MARTA along its corridors and the railroads (Norfolk Southern, CSX) on theirs. Typical crossings are the Downtown Connector, I-285, GA 400 and I-20, Peachtree Road and Roswell Road, the MARTA lines, the Norfolk Southern and CSX corridors through Inman and Tilford yards, the Beltline, Peachtree Creek, Nancy Creek and the Chattahoochee, and the airport approach roads around Hartsfield-Jackson.
Home territory
Davis Underground Solutions, Inc. is headquartered in Powder Springs, a short drive west of the Perimeter, so Fulton County is home territory: no mobilization fee, a site walk within days, and a crew that has already drilled the rock under Buckhead, the clay in Alpharetta and the fill around the airport. Davis Underground Solutions has the equipment list and project photos. Everything submitted on this site, and every call to (678) 264-3333, goes straight to the company. Estimates are free.
Price
Length, product size and material, what is crossed and how deep the permit wants it, rock or clay, and room on the surface for the rig and the pipe string. A Georgia 811 ticket and a site walk come first; the number that follows is firm. Send a sketch or the utility's drawing through the form on this page and you will have an answer within 24 hours.
Estimates are free. Call now: (678) 264-3333.
Other drilling and boring services in Fulton County
Horizontal Drilling Fulton County
Horizontal drilling for any line that has to cross something it cannot cut through: a street, a slab, a canal, a stand of trees. Entry pit, exit pit, nothing opened in between.
Directional Boring Fulton County
Directional boring is the small-rig end of HDD: short, shallow bores for service lines, sleeves and conduit on residential and light-commercial lots.
Underground Drilling Fulton County
Underground drilling for new utilities where the surface is spoken for: tracked, steered bores placed under whatever is already built on top.
Fiber Optic Cable Drilling Fulton County
Fiber duct and drop conduit installed by directional drill for carriers, co-ops, campuses and developments: long shots along the right-of-way, short shots to the building.
Electrical Conduit Drilling Fulton County
PVC and HDPE electrical conduit bored under pavement for primary feeds, secondary services, site lighting and EV charging circuits.
Underground Conduit Drilling Fulton County
Single ducts and multi-duct bundles pulled through one reamed bore: communications, power, controls and spares placed together under the obstacle.
Structured Cable Drilling Fulton County
Conduit between buildings for structured cabling, campus networks, security and controls, bored under courtyards, drives and parking rather than cut across them.
Utility Drilling Fulton County
Utility drilling for water, sewer, gas, power and telecom owners: permitted road crossings, mains under live streets, services to the meter.
Communications Drilling Fulton County
Communications conduit and cable placed by directional drill: telecom, cable TV, cell-site backhaul and private networks, under roads and lots.
Missile Boring Fulton County
Missile boring (pneumatic piercing) drives a steel mole through the soil for short, straight, shallow runs under a driveway or sidewalk: the quickest way to sleeve a lawn or a walk.
Auger Boring and Drilling Fulton County
Cased auger bores for road, highway and railroad crossings and for gravity sewer that has to hold an exact grade: a straight steel casing jacked from a pit.
Sewer, Water and Drain Lines Fulton County
New water services and mains, sewer force mains and laterals, and storm drains installed under roads, driveways and yards without trenching them open.
Questions about directional drilling in Fulton County
How deep is a bore under an Atlanta street?+
To the cover ATLDOT, Fulton County or GDOT requires for the road, plus whatever it takes to clear the utilities already there; four to eight feet is typical, deeper under the interstates and MARTA.
What happens when the bore hits rock?+
The crew expected it. A rock bit or a mud motor replaces the soil head, the daily footage drops, and the bore still gets made; rock changes the price per foot, not the method.
Who files Georgia 811 and the right-of-way permit?+
The contractor, as part of the job. The bore plan is drawn to the permit's depth and alignment before the rig is scheduled.
Is there a mobilization charge for Fulton County?+
No. The company is based in Powder Springs; Fulton County is home range.
How do I get a free estimate?+
Call (678) 264-3333 now or describe the run in the form on this page. Estimates are free and a reply comes within 24 hours.
Directional Drilling by city in Fulton County
Each community has its own page for this service. The crew, the method and the price are the same across the county; the page covers what is different about the ground and the permits there.
- Directional Drilling Atlanta
- Directional Drilling Alpharetta
- Directional Drilling Chattahoochee Hills
- Directional Drilling College Park
- Directional Drilling East Point
- Directional Drilling Fairburn
- Directional Drilling Hapeville
- Directional Drilling Johns Creek
- Directional Drilling Milton
- Directional Drilling Mountain Park
- Directional Drilling Palmetto
- Directional Drilling Roswell
- Directional Drilling Sandy Springs
- Directional Drilling Union City
ZIP codes served
30004, 30005, 30009, 30022, 30023, 30075, 30076, 30077, 30097, 30098, 30213, 30268, 30272, 30291, 30301, 30302, 30303, 30304, 30305, 30306, 30307, 30308, 30309, 30310, 30311, 30312, 30313, 30314, 30315, 30316, 30318, 30320, 30321, 30324, 30325, 30326, 30327, 30328, 30331, 30332, 30334, 30336, 30337, 30342, 30343, 30344, 30348, 30349, 30350, 30353, 30354, 30355, 30357, 30358, 30361, 30363, 30364, 30368, 30369, 30370, 30371, 30374, 30375, 30377, 30378, 30380, 30384, 30385, 30388, 30392, 30394, 30396, 30398, 31106, 31126, 31131, 31136, 31139, 31150, 31156, 31192, 31193, 31195, 31196